New: the AI firewall watches the whole platform and explains each incident in plain words. See how it works

Pump power calculator with energy cost

Free pump power calculator: hydraulic, shaft and electrical kW from flow, head and efficiencies, with the energy per cubic metre and the running cost.

This pump power calculator uses P = ρ × g × Q × H ÷ efficiencies: 100 m³/h against 50 m of head is 13.6 kW of hydraulic power, about 19.7 kW electrical at 75 % pump and 92 % motor efficiency.

In your currency; the cost lines use the same currency.

Electrical power
– kW
Energy per m³ pumped
– kWh/m³
Hydraulic power
– kW
Shaft power
– kW
Energy per day
– kWh
Wire-to-water efficiency
– %
Cost per day
–
Cost per month (30 days)
–

How it works

How do you calculate pump power?

Hydraulic power is ρ × g × Q × H: density, 9.80665 m/s², flow in m³/s and total head in metres. 100 m³/h against 50 m of head is 13.6 kW.

Shaft power is hydraulic power ÷ pump efficiency, and electrical power is shaft power ÷ motor efficiency (and drive efficiency, if you fold it in).

Energy per cubic metre is electrical power ÷ flow. It is the figure to watch over time: at the same head, a rising value points to wear or a pump running away from its best point.

In Hermetry Hermetry tracks specific energy (kWh used ÷ m³ pumped) per station and per day: Pumping station remote monitoring.

Glossary VFD (variable frequency drive), Energy monitoring

Questions

Questions about the pump power calculator

What is a typical pump efficiency?

Large clean-water pumps at their best point often reach 75 to 85 %; small pumps and pumps far from their best point are lower. The pump curve gives the real figure.

What is wire-to-water efficiency?

Hydraulic power out divided by electrical power in: the pump and motor (and drive) together. It is what the energy bill sees.