New: the AI firewall watches the whole platform and explains each incident in plain words. See how it works

Ohm’s law calculator and voltage divider

Free Ohm's law calculator: voltage, current, resistance and power from any two values, plus a voltage divider and the resistor it needs for a target output.

This Ohm’s law calculator uses V = I × R and P = V × I: 12 V across 4 Ω drives 3 A and dissipates 36 W. A voltage divider gives Vout = Vin × R2 ÷ (R1 + R2).

Voltage divider

Gives the R2 that makes this output with your R1.

Voltage
– V
Current
– A
Resistance
– Ω
Power
– W

Divider

Output voltage
– V
R2 for the target
– Ω
Current through the divider
– mA
Power in the divider
– mW

How it works

How do you use Ohm’s law and a voltage divider?

Ohm’s law links voltage, current and resistance: V = I × R, so I = V ÷ R and R = V ÷ I. Power is P = V × I.

An unloaded divider gives Vout = Vin × R2 ÷ (R1 + R2). For a target output, R2 = R1 × Vout ÷ (Vin − Vout).

A load on the output draws current and pulls the voltage down; keep the load’s resistance much higher than R2, or use a buffer.

Questions

Questions about the Ohm’s law calculator

How do I bring a 24 V signal to a 5 V input?

With a divider such as 10 kΩ over 2.7 kΩ (about 5.1 V), checking the input’s own resistance and the resistor power. A dedicated isolated input is safer for field wiring.

Why does my divider read low?

The input it feeds has its own resistance in parallel with R2, which lowers the output. Use smaller resistors or a buffer.