Greenhouse temperature and humidity monitoring needs sensors that sample the air the crop sits in: shaded from the sun, ventilated, kept dry and mounted at crop height. Choose humidity probes with a protective filter, plan to check them against a reference instrument, place at least two per zone, and watch the data for the patterns a failing sensor leaves.
I build automation for farms, and a vent or fogging rule acts on whatever the sensor reports.
Where should you place a temperature sensor in a greenhouse?
Place it among the plants at crop height, inside a radiation shield, away from doors, vents, heating pipes and the glass. I raise it as the crop grows, to keep it in the air at the growing tips.
A radiation shield keeps direct sun and water off the sensor. Without one, a sensor in sunlight reports its own heating rather than the air. A shield with a small fan draws a steady stream of air past the sensor, so the reading does not depend on a breeze that a closed greenhouse on a calm day may not have. The fan also pulls in mist, and a wet sensor reads low while the water on it evaporates, so keep fan-ventilated shields away from misting nozzles.
Why do humidity sensors fail?
Humidity elements get wet, get dirty and drift, so plan to check every humidity sensor in the field against a reference instrument.
A few choices reduce failures. I buy probes with a protective filter over the element, because the probe spends its life in damp air near misting lines. Prefer an element you can swap or check without taking down the mount, and clean a probe only the way its manual describes. A combined probe keeps temperature and humidity on the same air, which matters because relative humidity depends on air temperature.
How do you spot a dying sensor in the data?
Compare each sensor with its neighbour in the same zone and look for patterns the crop could not cause. Four patterns are worth an alert or a maintenance ticket:
- Humidity pinned at the top of its range for hours after the vents opened and the air warmed.
- A steady gap to the neighbouring sensor that grows week by week.
- A flat line: the same value for hours in a house where the climate swings every day.
- Afternoon temperature peaks that only one sensor shows, which points at a damaged or sunlit shield.
Flag those readings rather than deleting them, as in detecting outliers in sensor data.
Hermetry connects field devices to live dashboards, rules and alerts: IoT telemetry and SCADA in one platform. Its sensor regions ready solution groups temperature and humidity sensors by region, for example a farm’s greenhouse, orchard and storage hall, and draws each region’s floor plan with the sensors coloured by alarm state. Each sensor carries its own limits as attributes: a warning level and upper and lower critical limits, for temperature and for humidity. A sensor that sends nothing for 30 minutes raises an offline warning.
How do you send sensor data wirelessly from a greenhouse?
Use a low-power radio for battery sensors and keep Wi-Fi for spots with mains power. LoRaWAN is a low-power, wide-area networking specification designed to connect battery-operated devices, which suits sensors spread across several houses and a field.
I would test coverage with the crop fully grown, since a bay full of wet foliage is not the empty house you surveyed, and mount the gateway high. The same network can carry the soil probes covered in soil moisture sensor calibration. More on farm monitoring is on the agriculture page.
Frequently asked questions
How many sensors does a greenhouse need?
I put at least two in every zone with its own heating, vents or screens, so a failing sensor shows against its neighbour, and add more where the structure creates warm or damp corners.
How do you check a humidity sensor in the field?
Hold a calibrated reference instrument next to it while the air is steady and well below saturation. Two instruments with different response times disagree while conditions change. A lasting offset means recalibration or a new element.
Should a greenhouse sensor hang in the sun to see what the plants feel?
No. An unshielded sensor in sunlight measures its own heating, not the air. Leaf temperature is a separate measurement; keep the air sensor shaded and ventilated, and read the two side by side if leaf temperature matters to you.

