Did this to a pile of SG90s for a teaching rig. The mod:
1. Open the case, take out the output gear. Cut or file off the little plastic tab on its underside that hits the end stop.
2. The potentiometer under the output shaft is the position feedback. Unsolder it and put two 2.2k resistors in its place as a fixed divider (ends to the outer pads, the middle to the wiper pad). The servo now always thinks it’s at centre.
3. Reassemble. Now the pulse width sets speed and direction instead of position: about 1.5 ms stops it, shorter turns one way, longer the other. Find the exact stop value by trial, resistor tolerance shifts it.
To your second question: no, it no longer knows where it is, same as an FS90R. For a blind that matters, so do what Keisha said, add a reed switch or microswitch at fully open and fully closed, and count time or add a cheap encoder in between. Honestly, an SG90 is also weak for a real blind, a 28BYJ-48 stepper with a ULN2003 board gives you position for free and more torque.
On the board side: add blind.set with a Number parameter 0-100 to the ESP32’s profile Commands tab, Basic tier. The Slider sends the value once on release, not while you drag, which suits a motor. Have the ESP32 publish its real position as blind_pct and bind the Slider’s Current value to it, so the card shows where the blind actually is.
Power the servo or stepper from its own 5 V supply, not the ESP32’s pin.