oguz59

@oguz-ozkan · Joined May 2025

Newcomer

Akıllı şehir mühendisi · su ve atık su

Topics: 5
Replies: 36
Points: 0

Newcomer10 points to Member

Forum Replies Created

Posted April 20, 2026 at 8:25 am · in Can I switch the 12V garden lighting in my residential complex on and off with Hermetry City, or is there another way for now? #6

Translated from Türkçe by AI ·

We have the same setup in a park lighting test as well, and it works without problems with a sunset offset. Also send the battery voltage as telemetry, so if the panel is not enough in winter you will see it in advance.

Posted April 18, 2026 at 4:04 am · in Can I switch the 12V garden lighting in my residential complex on and off with Hermetry City, or is there another way for now? #2

Translated from Türkçe by AI ·

I looked into City too, but I couldn’t find a page in the docs describing what it offers. A regular device + rules is already enough for this job.

Posted March 12, 2026 at 10:35 am · in Is it sensible to power indoor battery sensors with harvested energy? #4

Translated from Türkçe by AI ·

Honestly, we have never tried harvesting on our site. We deploy LoRaWAN battery sensors and they last 5-6 years. Wi-Fi + TLS is expensive on every wake-up, so the problem is in front of harvesting, in my opinion.

Posted February 26, 2026 at 3:22 pm · in Rules by time, temperature and sunset for the boiler and balcony light in the apartment #4

Translated from Türkçe by AI ·

Thanks a lot, Ilgaz, the five rules were set up in ten minutes. I hadn’t entered the site’s location, so the sunset rule wasn’t saved; once I entered the location it worked. This evening the balcony light turned on by itself at 17:12, and my wife was really impressed 😄

Posted February 23, 2026 at 7:52 pm · in 400 metrelik RS485 hattının sonundaki sensörler öğlen saatlerinde düşüyor #4

Ekranı iki uçtan da topraklamadınız değil mi? Bizde bir hatta topraklama döngüsü yüzünden benzer saçmalıklar olmuştu.

Posted January 16, 2026 at 5:13 am · in Comparing two accelerometer sensors on the same pump in a single chart #4

Translated from Türkçe by AI ·

I think there’s a unit issue before the chart. What is 0.4? g? Peak or RMS? If the new one is in mm/s, then there’s no point putting both on the same axis.