Gestartet Schulungsaufbau: Was soll zwischen Raspberry Pi und Lego-Motoren sitzen?

Slightly unusual one. I'm building a training rig for our apprentices: a small Lego Technic conveyor with a colour sensor at the end, so…

vor 1 Woche

Gestartet PIC24FJ128GA202 Modbus RTU slave over MAX485 never answers the gateway

Our test rigs have a custom board with a PIC24FJ128GA202 that should act as a Modbus RTU slave (address 7, 19200 8E1) so a…

vor 1 Woche, 2 Tagen

Geantwortet auf Verpackungslinie 3: Presse, Roboterzelle, Prüfung, Verpacken und Palettieren in einer Zeichnung

Zones with a title per section is a good idea. Doing the same for our filling line.

vor 1 Woche, 4 Tagen

Geantwortet auf Der Commands-Tab auf einem neuen Controller, vor dem ersten Befehl

Who can send what here? Our operators are all Users.

vor 2 Wochen, 4 Tagen

Geantwortet auf Serhat, SCADA drawings and the field side under them

Hello Serhat. Automotive here. Is there anything in the library for assembly lines, or is it mostly tanks and pumps?

vor 2 Monaten, 2 Wochen

Geantwortet auf Measuring 1250 °C in a pottery kiln and getting told when a firing runs away

MAX6675 tops out at 1024 °C by design, that's your 1023.75.

vor 3 Monaten, 3 Wochen

Geantwortet auf Reject button at a rework station misses quick presses. Also, can Forge count these for us?

Interrupt version is on the station since Monday. Hand tally 52, Hermetry 52 on Tuesday's shift. I'd also been publishing "rejects this minute" and…

vor 4 Monaten, 1 Woche

Gestartet Reject button at a rework station misses quick presses. Also, can Forge count these for us?

We have a rework station at the end of a door panel line. When an operator rejects a panel they press a big mushroom…

vor 5 Monaten, 2 Wochen