Iniciados Banco de formación: ¿qué debería ir entre una Raspberry Pi y los motores Lego?

Slightly unusual one. I'm building a training rig for our apprentices: a small Lego Technic conveyor with a colour sensor at the end, so…

hace 1 semana

Iniciados PIC24FJ128GA202 Modbus RTU slave over MAX485 never answers the gateway

Our test rigs have a custom board with a PIC24FJ128GA202 that should act as a Modbus RTU slave (address 7, 19200 8E1) so a…

hace 1 semana, 2 días

Respondidos Línea de envasado 3: prensa, celda robótica, inspección, embalaje y paletizado en un solo dibujo

Zones with a title per section is a good idea. Doing the same for our filling line.

hace 1 semana, 4 días

Respondidos La pestaña Commands en un controlador nuevo, antes del primer comando

Who can send what here? Our operators are all Users.

hace 2 semanas, 4 días

Respondidos Serhat, SCADA drawings and the field side under them

Hello Serhat. Automotive here. Is there anything in the library for assembly lines, or is it mostly tanks and pumps?

hace 2 meses, 2 semanas

Respondidos Measuring 1250 °C in a pottery kiln and getting told when a firing runs away

MAX6675 tops out at 1024 °C by design, that's your 1023.75.

hace 3 meses, 3 semanas

Respondidos Reject button at a rework station misses quick presses. Also, can Forge count these for us?

Interrupt version is on the station since Monday. Hand tally 52, Hermetry 52 on Tuesday's shift. I'd also been publishing "rejects this minute" and…

hace 4 meses, 1 semana

Iniciados Reject button at a rework station misses quick presses. Also, can Forge count these for us?

We have a rework station at the end of a door panel line. When an operator rejects a panel they press a big mushroom…

hace 5 meses, 2 semanas