New: the AI firewall watches the whole platform and explains each incident in plain words. See how it works

Cold room temperature monitoring that holds up in a HACCP check

A probe that reads is not a HACCP record. Probe placement, logging frequency, gaps and corrective actions, measured against the Codex food hygiene text.

Cold room temperature monitoring holds up in a HACCP check when the record shows readings taken often enough to catch a slow rise, no unexplained gaps, and a documented corrective action for every deviation, with its cause and what happened to the product. The Codex HACCP guidance lists monitoring, deviations with corrective actions, and verification among the records to keep.

The reference text for that check is the Codex General Principles of Food Hygiene (CXC 1-1969), which contains the HACCP principles.

Where should you place a temperature probe in a cold room?

Place it where product is warmest, not where the air is coldest. The air leaving the evaporator is the coldest in the room, and the air near the door warms at every opening, so one probe in either spot gives a misleading picture.

I would start with one probe in the warmest product zone, out of the evaporator air stream, and add a second near the door if the room is opened often. A probe in a small container of liquid follows product temperature more closely than an air probe, which reacts to every door opening and defrost. Codex expects temperature monitoring devices to be checked for accuracy and calibrated at regular intervals or as needed.

How often should cold room temperatures be logged?

Codex sets no fixed interval. For a critical control point (CCP), it asks that the monitoring method and frequency detect a failure in time to isolate and evaluate the product, names “a gradual increase in temperature in cold storage” as one kind of deviation to plan for, and asks for continuous monitoring where possible.

A logger that reads every few minutes comes close to continuous for a room whose temperature moves slowly. A door left open for twenty minutes can still vanish inside an hourly figure (more on what an hourly average hides). Alarm on the raw readings, with a short delay so a defrost cycle does not page anyone, and keep one bad reading out of your alarms.

What records does HACCP need for temperature?

Codex gives three examples of HACCP records: CCP monitoring activities, deviations and associated corrective actions, and verification procedures performed. Whether or not your plan treats the cold room as a CCP, these are the three records I would keep.

RecordWhat Codex says it should hold
CCP monitoringThe results and timing, signed or initialled by the person performing the monitoring
Corrective actionDetails of the action, including the cause of the deviation and what happened to the product
VerificationReviews of monitoring and corrective action records, and instrument accuracy checks, by someone other than the person responsible for monitoring and corrective actions

Records may be electronic. On a paper sheet the initials show who monitored; in an electronic record, I would make sure every check, acknowledgement and note carries a named person rather than a shared login.

Hermetry connects field devices to live dashboards, rules and alerts: IoT telemetry and SCADA in one platform. On its alarm page, an operator acknowledges an alarm, and whoever clears it (an admin by default) can add a note of up to 2,000 characters saying what they did; the note stays with the alarm for its whole history. The page shows the rule’s runbook and a timeline of every step with who did it, and the docs suggest reviewing resolved alarms that were never acknowledged, for example once per shift.

What happens to the record when the network drops?

A gap with no explanation looks like monitoring that did not happen. A logger that stores readings locally and sends them later with their original timestamps closes the gap; one that only sends live values leaves a hole to explain by hand. For a design that covers sensors, alarms and review boards together, see cold room and freezer temperature monitoring, and for food plants in general, food IoT and SCADA.

Frequently asked questions

Do I need to check an electronic temperature logger against a thermometer?

Codex says temperature monitoring and recording devices should be checked for accuracy and calibrated at regular intervals or as needed, and lists calibrating or checking the accuracy of monitoring instruments among verification activities. A comparison against a calibrated reference thermometer is one way to do the check; record the result.

Can HACCP temperature records be kept electronically?

Yes. Codex says records can be maintained electronically where appropriate, that a simple record-keeping system can be effective, and that documentation should suit the nature and size of the operation.

Who should review cold room temperature records?

Codex says monitoring data should be evaluated by a designated person with the knowledge and authority to carry out corrective actions, and that verification should be carried out by someone other than the person responsible for performing the monitoring and corrective actions.

Share

See your field data live this week

Start a trial in your region with your first devices, or book a demo and bring your own use case.