james56
@james_p56 · Membre depuis août 2026
Automation engineer · manufacturing
- Sujets
- 2
- Réponses
- 14
- Points
- 0
Activité récente
-
We did it with commands on a smaller fleet and it was a mess every time a unit missed one. Nobody could tell which…
-
Réponses à 2.2.0 : les convoyeurs reçoivent une largeur et une hauteur, leurs points de connexion y sont liés
Rebuilt our palletising screen with the belt widths set to match the real belts. Works for us.
-
Réponses à Uno avec un adaptateur 12 V et USB en même temps : cela va-t-il griller mon portable ?
No, the Uno handles both. But how is the relay powered, and where do the grounds meet? The jumping readings and the disappearing port…
-
Réponses à La Uno se réinitialise à chaque ouverture de /dev/ttyUSB0 par mon script Pi
DTR is one of the old modem control lines. On the Uno it goes through a 100 nF capacitor to the reset pin, so…
-
Réponses à Showing an inspection drone’s position and flight path live on a board
Did this for a roof inspection drone, so here's what I ended up with.On the Pi, pymavlink reads the MAVLink stream from TELEM2. You…
-
Isn't there a relay feature? I'm sure I saw a gateway status called Pending somewhere in the gateway list.
-
Réponses à Vingt sondes DS18B20 sur un seul Pi : pertes au-delà de huit capteurs et comment nommer les clés
The star is your dropout problem. 1-wire hates stubs, every leg reflects. Either run one line past every probe with tiny stubs, or split…
-
Réponses à ttyAMA0, ttyS0, serial0 : lequel mon HAT Modbus doit-il utiliser sur un Pi 3B+ ?
disable-bt plus removing the console did it. 600 polls overnight, zero CRC errors, zero timeouts. I was on ttyAMA0 talking to… nothing useful apparently,…

