thompsonfw
@mthompson · Se unió el agosto 2025
Embedded developer · agriculture · 4 years in the field
- Temas
- 5
- Respuestas
- 24
- Puntos
- 0
Actividad reciente
-
Respondidos 2.2.2: los dispositivos detrás de una puerta de enlace envían datos y reciben comandos a través de ella
Perfect timing. I have a Pi 4 reading six energy meters over RS-485 with pymodbus. Which topic do the readings go to, and do…
-
Good that Timed out is worded as "outcome unknown" and not as failed. On a weak cell link our boards often run the relay…
-
Aisha's right. And the catch is the ecosystem: very few meters speak it, so you'd be tied to that one vendor for the meters…
-
Respondidos ¿Mantener MQTT abierto en LTE o reconectar en cada envío? Intentamos reducir la factura de datos
Nice. If the pumps ever need commands, keep in mind a reading batched for 15 minutes doesn't delay those, they come down the open…
-
Respondidos ¿Mantener MQTT abierto en LTE o reconectar en cada envío? Intentamos reducir la factura de datos
Your colleague #2 is probably right. A full TLS handshake costs kilobytes, a keepalive ping is tiny.
-
Respondidos Sistema de archivos de solo lectura en mi Pi gateway con RaspAP: ¿qué pasa con las lecturas en búfer?
SD corruption on power loss is the classic Pi failure. Overlay FS through raspi-config (Performance Options > Overlay File System) works well.
-
For the pucks: mount the gateway high and as close as you can, asphalt plus a car on top eats a lot of signal.…
-
Respondidos Pump relay on an ESP32 clicks at boot and the board switch says On when it isn’t
Moved to GPIO 26 with the HIGH-before-OUTPUT trick, no more click across 20 reboots. Bound the switch to pump_state and the firmware reports after…