Yeni: Yapay zekâ güvenlik duvarı tüm platformu izliyor ve her olayı sade bir dille açıklıyor. Nasıl çalıştığını görün

Michael Thompson

thompsonfw

@mthompson · Ağustos 2025 tarihinde katıldı

Yeni üye

Embedded developer · agriculture · 4 years in the field

Konular
5
Yanıtlar
24
Puan
0
Yeni üye10 için Üye puan

Son etkinlik

  1. Yanıtlanan 2.2.2: Ağ geçidinin arkasındaki cihazlar verilerini bu geçit üzerinden gönderir ve komutları bu geçit üzerinden alır

    Perfect timing. I have a Pi 4 reading six energy meters over RS-485 with pymodbus. Which topic do the readings go to, and do…

  2. Yanıtlanan 2.2.0: cihaz listesi ve cihaz sayfası, profil düzenleyici, Commands sekmesi ve cihaz günlüğü

    Good that Timed out is worded as "outcome unknown" and not as failed. On a weak cell link our boards often run the relay…

  3. Yanıtlanan Bir kasabanın su sayaçları için TV beyaz boşluk radyoları mı LoRaWAN mı, ve Hermetry City şu an kullanılabilir mi?

    Aisha's right. And the catch is the ecosystem: very few meters speak it, so you'd be tied to that one vendor for the meters…

  4. Yanıtlanan LTE üzerinde MQTT bağlantısını açık mı tutalım yoksa her gönderimde yeniden mi bağlanalım? Veri faturamızı düşürmeye çalışıyoruz

    Nice. If the pumps ever need commands, keep in mind a reading batched for 15 minutes doesn't delay those, they come down the open…

  5. Yanıtlanan LTE üzerinde MQTT bağlantısını açık mı tutalım yoksa her gönderimde yeniden mi bağlanalım? Veri faturamızı düşürmeye çalışıyoruz

    Your colleague #2 is probably right. A full TLS handshake costs kilobytes, a keepalive ping is tiny.

  6. Yanıtlanan RaspAP ağ geçidi Pi'mde salt okunur dosya sistemi: tamponlanmış okumalara ne olur?

    SD corruption on power loss is the classic Pi failure. Overlay FS through raspi-config (Performance Options > Overlay File System) works well.

  7. Yanıtlanan Küçük bir kasaba pilotu için park yeri sensörleri: Hermetry City mi, yoksa düz LoRaWAN ve kartlar mı?

    For the pucks: mount the gateway high and as close as you can, asphalt plus a car on top eats a lot of signal.…

  8. Yanıtlanan Pump relay on an ESP32 clicks at boot and the board switch says On when it isn’t

    Moved to GPIO 26 with the HIGH-before-OUTPUT trick, no more click across 20 reboots. Bound the switch to pump_state and the firmware reports after…