Neu: Die KI-Firewall überwacht die gesamte Plattform und erklärt jeden Vorfall in einfachen Worten. So funktioniert es

brian14

@russo-b · Mitglied seit Dezember 2025

Neuling

IT and security admin · energy

Themen
4
Antworten
7
Punkte
0
Neuling10 Punkte an Mitglied

Letzte Aktivität

  1. Geantwortet auf Sensoren auf dem Hof am Rand des WLANs: Warum wird es so langsam, und was kann ich dagegen tun?

    Thanks, the explanation helped me write it up for my manager. Batched to one message every 2 minutes with 4 readings and keepalive 90…

  2. Geantwortet auf Sensoren auf dem Hof am Rand des WLANs: Warum wird es so langsam, und was kann ich dagegen tun?

    2.4 GHz, 20 MHz channels. The ESP32 can't do 5 GHz anyway.

  3. Gestartet Sensoren auf dem Hof am Rand des WLANs: Warum wird es so langsam, und was kann ich dagegen tun?

    IT admin, I look after networks more than sensors. We have 8 ESP32 sensor boxes in an outdoor storage yard, at the edge of…

  4. Geantwortet auf Das Audit-Log lesen: wer was getan hat und prüfen, ob niemand es verändert hat

    We'd rather push high severity events into our SIEM than poll the API. Any hook for that?

  5. Geantwortet auf Nackte Si4463-Funkmodule: Wo stecken funktionierende Arduino-Beispiele?

    SDN was floating. Tied it through the library pin and init succeeded on the first try. Sender at the tank, receiver on a second…

  6. Gestartet Nackte Si4463-Funkmodule: Wo stecken funktionierende Arduino-Beispiele?

    Different project from my pigpio question. We have a water tank about 900 m from the building, no power to spare and no cable.…

  7. Geantwortet auf Pi-Gateway: "RTNETLINK answers: File exists" bei ifup eth0 und Keepalive-Abbrüche nach dem Booten

    Fixed. Interfaces file cleaned, static config in dhcpcd.conf with noipv4ll, rebooted the Pi ten times in a row this morning and the gateway connected…

  8. Geantwortet auf Pi-Gateway: "RTNETLINK answers: File exists" bei ifup eth0 und Keepalive-Abbrüche nach dem Booten

    Yes, ifdown says interface eth0 not configured and ifup fails the same way afterwards.