aisha.maker
@aisha_r58 · Mitglied seit Oktober 2025
Maker · home automation · Brisbane
- Themen
- 7
- Antworten
- 40
- Punkte
- 0
Letzte Aktivität
-
Geantwortet auf Den Log-Tab eines Geräts lesen: Verbindungen, Trennungen und Session-Übernahmen
Mine has no connect rows at all, only changes. The device is an SNMP box.
-
Geantwortet auf ESP8266 als lokaler MQTT-Broker, damit die Sensoren weiterlaufen, wenn das Internet ausfällt?
uMQTTBroker works, I ran it for a while. No TLS, and it fell over at about 8 clients for me.
-
Geantwortet auf Two Unos over a pair of HC-05s so the one with the GSM modem reports both
Fast blink means not connected. Once they link you get two quick blinks every couple of seconds.
-
Geantwortet auf ESP32-WROOM vs WROVER vs MINI: what do the module names mean and which do I buy?
I use a DevKitC board with a WROOM-32E on it for everything at home, plug in USB and go.
-
Geantwortet auf Günstigste Möglichkeit, einen PoE-betriebenen Controller aus meiner Werkstatt melden zu lassen
Hermetry doesn't care, it only sees a TLS connection on 8883 (or HTTPS on 443). Ethernet or WiFi is invisible to it. For one…
-
Geantwortet auf Freezer at -12.5 C shows up as 65411 after going through my Modbus slave
Same goes for 32-bit values split over two registers, then you also have to get the word order right. Fun times.
-
Geantwortet auf Serielle Konsole zu meinem Pi-Gateway zeigt Escape-Codes statt Farben, und htop ist ein Durcheinander
TERM was vt220, exactly. With the bashrc block it's colours and a full-width htop over serial now. I also added Eric's tip, the service…
-
Geantwortet auf Serielle Konsole zu meinem Pi-Gateway zeigt Escape-Codes statt Farben, und htop ist ein Durcheinander
Same thing in picocom from my Linux box, I tried.

