Quick one, embarrassing probably. I’m using an HC-05 as a serial bridge so a lab balance can send weights to a gateway that forwards them to Hermetry. I want to rename the module and set its baud to 9600.
Holding the button at power-up, LED blinks slowly every 2 s, so it’s in AT mode. I’m sending from an Uno sketch that passes the Serial Monitor through to the HC-05 at 38400. «AT» gives «OK». Everything else:
AT+NAME=BAL-07
ERROR:(0)
AT+UART=9600,0,0
ERROR:(0)Maybe the baud rate is wrong? Try 9600 in the sketch.
Same thing happened to me with one from a starter kit, following.
The baud is right, otherwise plain AT wouldn’t answer OK either. ERROR:(0) is the HC-05’s code for a command it couldn’t parse, and with this module that almost always means the line ending. It wants every command to end with CR+LF. If the Serial Monitor is on «No line ending» or «Newline» only, the short «AT» sometimes gets through and the longer commands don’t.
Set the monitor to «Both NL & CR». Also type the commands in capitals, and on some firmware versions AT+NAME only works while the KEY/EN pin is held high the whole time, not only at power-up. If NAME still fails, tie KEY to 3.3 V with a wire while you send it.
AT+UART=9600,0,0 then sets the data mode baud. AT mode stays at 38400 regardless.
Monitor was on «Newline». Both NL & CR and NAME and UART went through at once. Kevin, the baud was fine, AT mode is always 38400 on these.
- Debes estar registrado para responder a este debate.
Únete a la conversación
Inicia sesión para preguntar y responder, dar me gusta a las publicaciones útiles y marcar la respuesta que resolvió tu problema. Cada aportación suma puntos y niveles.