Quick one, embarrassing probably. I’m using an HC-05 as a serial bridge so a lab balance can send weights to a gateway that forwards them to Hermetry. I want to rename the module and set its baud to 9600.
Holding the button at power-up, LED blinks slowly every 2 s, so it’s in AT mode. I’m sending from an Uno sketch that passes the Serial Monitor through to the HC-05 at 38400. „AT“ gives „OK“. Everything else:
AT+NAME=BAL-07
ERROR:(0)
AT+UART=9600,0,0
ERROR:(0)Maybe the baud rate is wrong? Try 9600 in the sketch.
Same thing happened to me with one from a starter kit, following.
The baud is right, otherwise plain AT wouldn’t answer OK either. ERROR:(0) is the HC-05’s code for a command it couldn’t parse, and with this module that almost always means the line ending. It wants every command to end with CR+LF. If the Serial Monitor is on „No line ending“ or „Newline“ only, the short „AT“ sometimes gets through and the longer commands don’t.
Set the monitor to „Both NL & CR“. Also type the commands in capitals, and on some firmware versions AT+NAME only works while the KEY/EN pin is held high the whole time, not only at power-up. If NAME still fails, tie KEY to 3.3 V with a wire while you send it.
AT+UART=9600,0,0 then sets the data mode baud. AT mode stays at 38400 regardless.
Monitor was on „Newline“. Both NL & CR and NAME and UART went through at once. Kevin, the baud was fine, AT mode is always 38400 on these.
- Du musst angemeldet sein, um auf dieses Thema antworten zu können.
Mitdiskutieren
Melde dich an, um Fragen zu stellen und zu beantworten, hilfreiche Beiträge mit „Gefällt mir“ zu markieren und die Antwort zu kennzeichnen, die dein Problem gelöst hat. Jeder Beitrag bringt Punkte und Stufen.