emily23
@smith-e · Mitglied seit Januar 2026
Facility manager · hospitality
- Themen
- 5
- Antworten
- 26
- Punkte
- 0
Erstellte Forenantworten
Von English mit KI übersetzt ·
Ein kleines UPS-HAT würde verhindern, dass Stromausfälle überhaupt zum Problem werden.
A small UPS HAT would stop the power cuts being a problem at all.
Von English mit KI übersetzt ·
Die Powerbank schaltet sich selbst ab. Genau das hatten wir letztes Jahr bei uns am Objekt mit einem Türzähler.Die meisten Powerbanks schalten ihren Ausgang ab, wenn die Last für einige Sekunden unter etwa 50-100 mA fällt, weil sie denken, das Handy sei voll. Dein Nano zieht während des Funkversands weit mehr als das, und im Schlafmodus per LowPower nur wenige mA (oder weniger). Also: Join, erster Uplink, Schlaf, die Powerbank sieht kaum noch Strom, Ausgang aus. Im Code lässt sich dagegen nichts tun. Ein Neustecken startet die Powerbank neu.Auswege, nach dem was wir ausprobiert haben:
- Eine Stromquelle ohne diese Funktion verwenden: 3 x AA-Alkalibatterien direkt an den 5-V-Pin sind für ein Nano (4,5 V) eine Weile in Ordnung, besser ist aber ein LiPo mit einem guten Regler mit niedrigem Ruhestrom. Ein nackter Pro Mini mit 3,3 V und entferneter Power-LED läuft mit AAs monatelang.
- Manche Powerbanks haben einen Modus „Always on“ oder für geringen Strom, meist durch zweimaliges Drücken der Taste. Schau ins Handbuch.
- Dummy-Lasten, die Impulse ziehen und die Powerbank wach halten, funktionieren, verbrauchen aber den größten Teil des Akkus.
Passe außerdem Hermetry an den Sensor an. Beim eingebauten LoRaWAN-Profil gilt das Gerät als online, solange der letzte Uplink jünger als das Dreifache des erwarteten Intervalls ist; das Standardintervall ist 3.600 s. Bei einem Uplink alle 10 Minuten passt alles. Wenn du zum Stromsparen auf stündlich oder seltener umstellst, erhöhe das erwartete Intervall im Reiter Online-Status des Profils, sonst wechselt es zwischen den Meldungen auf offline. Das steht in Troubleshooting uplinks and downlinks.
It’s the power bank switching itself off. Had exactly this at our property with a door counter last year.
Most power banks shut their output down when the load drops below somewhere around 50-100 mA for a few seconds, because they think the phone is full. Your Nano draws far more than that while the radio is sending, and a few mA (or less) when LowPower puts it to sleep. So: join, first uplink, sleep, power bank sees almost no current, output off. Nothing for the code to do about it. Replugging restarts the bank.
Ways out, from what we tried:
- Use a power source without that feature: 3 x AA alkaline straight to the 5 V pin is ok for a Nano (4.5 V) for a while, or better a LiPo with a decent low-quiescent regulator. A bare Pro Mini at 3.3 V with the power LED removed runs for months on AAs.
- Some power banks have an „always on“ or low-current mode, usually a double press of the button. Check the manual.
- Dummy loads that pull pulses to keep the bank awake work, but they waste most of the battery.
Also adjust Hermetry so it matches the sensor. On the built-in LoRaWAN profile the device counts as online while the last uplink is younger than three expected intervals, with 3,600 s as the default interval. At one uplink per 10 minutes you’re fine, but if you stretch it to hourly or longer to save battery, raise the expected interval on the profile’s Online status tab, otherwise it flips to offline between reports. That bit is in Troubleshooting uplinks and downlinks.
Von English mit KI übersetzt ·
Im Anschluss möchte ich dasselbe für unsere Küchenkühlschränke machen.
Following, I want to do the same for our kitchen fridges.
Von English mit KI übersetzt ·
Welche tatsächlichen Widerstandswerte hat der Spannungsteiler auf Ihrem Board, und welchen ADC-Wert liefert der ESP32 bei 12,6 V?
What are the actual divider values on your board, and what’s the ESP32’s ADC reading at 12.6 V?
Von English mit KI übersetzt ·
Läuft jetzt seit einer Woche! Die Meldung „Für Sonnenaufgang und Sonnenuntergang wird der Standort dieses Ortes benötigt“ habe ich genau so bekommen, die Koordinaten hinzugefügt, und es wurde gespeichert. Außerdem habe ich eine zweite Ausschaltregel um 23:05 ergänzt, weil eine Steckdose den Code inzwischen ab und zu verpasst. Das Personal hat nichts bemerkt, außer dass die Heizstrahler jetzt einfach dann an sind, wenn sie sollen.
Running for a week now! „Sunrise and sunset need this place’s location“ was exactly the message I got, added the coordinates and it saved. I also added a second off rule at 23:05 because one socket misses the code now and then. Staff noticed nothing except the heaters are just on when they should be.
Von English mit KI übersetzt ·
Das war es, Current value war an den Befehlsparameter statt an einen gemeldeten Schlüssel gebunden. Der Auftragnehmer hat die Veröffentlichung nach dem Tastendruck und eine Wiederholung alle 5 Minuten mit dem CO2-Messwert hinzugefügt. Der Schieberegler folgt jetzt den Wandtastern. Die Abfrage „Vor dem Ausführen fragen“ ist deaktiviert, das Eventteam bedankt sich.
That was it, Current value was bound to the command parameter instead of a reported key. Contractor added the publish after the button press and a repeat every 5 minutes with the CO2 reading. Slider follows the wall buttons now. Ask before running is off, the events team thanks you.
Von English mit KI übersetzt ·
ok, ich habe das Sender- + Empfänger-Paar bestellt. Den Pi-Teil verstehe ich jetzt, aber wie löse ich das von Hermetry aus bei Sonnenuntergang aus?
ok I ordered the transmitter + receiver pair. So the Pi part is clear, but how do I trigger it from Hermetry at sunset?
Von English mit KI übersetzt ·
Von uns auch ein +1. Der Events-Trick ist für den Moment ein guter Tipp.
+1 from us too. The events trick is a good tip for now.
Von English mit KI übersetzt ·
Ist überhaupt nicht mein Fachgebiet, aber ich verfolge die Diskussion mit. Bei uns im Hotel hat die Fettabscheider-Pumpe ständig Verstopfungen.
Not my field at all, but following, our hotel has a grease trap pump that’s always clogging.
Von English mit KI übersetzt ·
Keine Tokens pro Tag, perfekt. Sag mir Bescheid, wenn du ein Angebot hast.
No tokens per tag, perfect. Let me know when you have a quote.
Von English mit KI übersetzt ·
Hotelseite hier (nicht die Gruppe, aber derselbe Bedarf). Was auch immer ihr macht, ich kann nicht 500 Gerätetoken in Hermetry eintippen.
Hotel side here (not that group, but same need). Whatever you do, I can’t be typing 500 device tokens into Hermetry.

