harrisplc
@lauraharris78 · Mitglied seit Februar 2025
Automation engineer · automotive
- Themen
- 5
- Antworten
- 9
- Punkte
- 0
Letzte Aktivität
-
Gestartet Schulungsaufbau: Was soll zwischen Raspberry Pi und Lego-Motoren sitzen?
Slightly unusual one. I'm building a training rig for our apprentices: a small Lego Technic conveyor with a colour sensor at the end, so…
-
Gestartet PIC24FJ128GA202 Modbus-RTU-Slave über MAX485 antwortet dem Gateway nie
Our test rigs have a custom board with a PIC24FJ128GA202 that should act as a Modbus RTU slave (address 7, 19200 8E1) so a…
-
Geantwortet auf Verpackungslinie 3: Presse, Roboterzelle, Prüfung, Verpacken und Palettieren in einer Zeichnung
Zones with a title per section is a good idea. Doing the same for our filling line.
-
Geantwortet auf Der Commands-Tab auf einem neuen Controller, vor dem ersten Befehl
Who can send what here? Our operators are all Users.
-
Geantwortet auf Serhat, SCADA-Zeichnungen und die Feldebene darunter
Hello Serhat. Automotive here. Is there anything in the library for assembly lines, or is it mostly tanks and pumps?
-
Geantwortet auf 1250 °C in einem Töpferofen messen und benachrichtigt werden, wenn ein Brand außer Kontrolle gerät
MAX6675 tops out at 1024 °C by design, that's your 1023.75.
-
Geantwortet auf Reject-Taster an der Nacharbeitsstation erfasst schnelle Tastendrücke nicht. Kann Forge das auch für uns zählen?
Interrupt version is on the station since Monday. Hand tally 52, Hermetry 52 on Tuesday's shift. I'd also been publishing "rejects this minute" and…
-
We have a rework station at the end of a door panel line. When an operator rejects a panel they press a big mushroom…

