davidp11
@david-patel · Mitglied seit März 2025
Facility manager · hospitality · new to IoT
- Themen
- 8
- Antworten
- 63
- Punkte
- 0
Erstellte Forenantworten
Von English mit KI übersetzt ·
Wir verwenden im Hotel dasselbe Feather-Setup; ein 8-Kanal-Basics-Station-Indoor-Gerät kostete etwa so viel wie zwei Feathers
we use the same Feather setup at the hotel, an 8-channel Basics Station indoor unit was about the price of two Feathers
Von English mit KI übersetzt ·
Vielleicht eine dumme Frage, aber warum schreibt man das WLAN nicht einfach einmal in den Code, wenn es doch alles im selben Campus ist?
Possibly a dumb question but why not just put the Wi-Fi in the code once, if it’s all the same campus?
Von English mit KI übersetzt ·
Das Gleiche ist mir mit einem aus einem Starter-Kit passiert, ich verfolge den Thread.
Same thing happened to me with one from a starter kit, following.
Von English mit KI übersetzt ·
Nicht mein Fachgebiet, aber unser Bauunternehmer hatte ähnliche Probleme bei einem langen Kabel, und es lag an der Erdung. Nur für den Fall.
Not my field, but our building contractor had similar issues on a long cable and it turned out to be grounding. Just in case.
Von English mit KI übersetzt ·
Ich habe vor meiner Arbeit mit IoT viele Beleuchtungsnachrüstungen in Hotels gemacht, deshalb kenne ich mich hier aus.Besorge dir einen Konstantstrom-Buck-Modul mit Dim-Eingang. Die günstigen, die auf dem PT4115 basieren, kosten ein paar Dollar, gibt es in 700-mA-Versionen (oder per Messwiderstand eingestellt), sie akzeptieren 12 bis 24 V und haben einen DIM-Pin. Ein Mean Well LDD-700H ist die bessere Markenvariante. Gib ihm 12 V, die LED kommt an den Ausgang, und der PWM-Pin deines ESP8266 geht direkt an DIM. 3,3 V PWM reicht für beides. Bei etwa 1 kHz PWM sieht man kein Flackern, und der Treiber hält den Strom konstant, während sich die LED erwärmt.Auf der Hermetry-Seite: Füge dem Katalog des Profils einen Befehl wie light.set mit einem Zahlenparameter als Basic-Befehl hinzu und dann eine Slider-Kontrollkarte, die ihn ausführt. Der Schieber sendet einmal, wenn du loslässt, nicht während des Ziehens. Bei einem Licht schalte ich Ask vor dem Ausführen aus, sonst bekommt der Schichtleiter bei jedem Mal ein Bestätigungsfenster. Binde den aktuellen Wert an das, was der ESP zurückmeldet (ich sende light.level nach jeder Änderung), damit der Schieber zeigt, was das Licht tatsächlich macht. Control cards erklärt das Schritt für Schritt.
I did a lot of lighting retrofits at the hotels before I touched any IoT, so this one I know.
Get a constant current buck module with a dim input. The cheap ones built around a PT4115 cost a couple of dollars, come in 700 mA versions (or set by a sense resistor), take 12 to 24 V and have a DIM pin. A Mean Well LDD-700H is the nicer branded one. Feed it 12 V, LED on the output, and your ESP8266 PWM pin straight into DIM. 3.3 V PWM is enough for both of those. Around 1 kHz PWM, no flicker you can see, the driver keeps the current flat as the LED heats up.
On the Hermetry side: add a command like light.set with a number parameter to the profile’s catalog as a Basic command, then a Slider control card that runs it. The slider sends once when you let go, not while dragging. For a light I switch off Ask before running, otherwise the shift lead gets a confirm box every time. Bind the current value to what the ESP reports back (I send light.level after each change), so the slider shows what the light is really doing. Control cards walks through it.
Von English mit KI übersetzt ·
Ich lerne das Thema noch, aber ich habe für die Poolchemie in unserem Hotel dieselbe Art von Alarm eingerichtet, daher kann ich den zweiten Teil übernehmen.Bei Alarmbedingungen gibt es kein „zwischen“. Man schreibt es als Gruppe. Das Formular führt pro Schweregrad nur einen Vergleich durch, also wechsle die Regel in den JSON-Modus:
"severities": [
{ "severity": "MAJOR",
"condition": { "any": [
{ "key": "ph", "op": "<", "value": 5.5 },
{ "key": "ph", "op": ">", "value": 6.5 } ] } }
],
"debounce": { "mode": "duration", "raise": 300, "clear": 60 },
"hysteresis": 0.1
Das Duration-Debounce verhindert den Einbruch durch die Dosierung. Die Bedingung muss 300 Sekunden lang laut den eigenen Zeitstempeln des Geräts wahr sein, bevor der Alarm auslöst. Unser Chlor-Dosiereinbruch dauert etwa zwei Minuten, daher waren 5 Minuten sicher. Da du alle 30 s meldest, sind das zehn Messwerte in Folge, mehr als genug.Hysterese 0,1 bedeutet, dass er auf der unteren Seite bei 5,6 oder darüber zurückgesetzt wird, auf der oberen Seite bei 6,4 oder darunter, sodass er an der Grenze nicht flackert.Alles dazu steht in der Alarm conditions reference, der Debounce-Teil auf der Seite daneben.
I’m still learning this stuff, but I set up the same kind of alarm for the pool chemistry at our hotel, so I can do the second half.
There’s no „between“ in alarm conditions, you write it as a group. The form does one comparison per severity, so switch the rule to JSON mode:
"severities": [
{ "severity": "MAJOR",
"condition": { "any": [
{ "key": "ph", "op": "<", "value": 5.5 },
{ "key": "ph", "op": ">", "value": 6.5 } ] } }
],
"debounce": { "mode": "duration", "raise": 300, "clear": 60 },
"hysteresis": 0.1
The duration debounce is what stops the dosing dip. The condition has to be true for 300 seconds by the device’s own timestamps before the alarm opens. Our chlorine dose dip lasts about two minutes, so 5 minutes was safe. Since you report every 30 s that’s ten readings in a row, plenty.
Hysteresis 0.1 means it clears at 5.6 or above on the low side, 6.4 or below on the high side, so it doesn’t flap at the edge.
All of this is on Alarm conditions reference, and the debounce part on the page next to it.
Von English mit KI übersetzt ·
Würde das nicht die Verschlüsselung des SIM-Anbieters abdecken? Ich dachte, Mobilfunknetze verschlüsseln ohnehin alles über die Luftschnittstelle.
Wouldn’t the SIM provider’s encryption cover that? I thought mobile networks encrypt everything over the air anyway.
Von English mit KI übersetzt ·
Läuft seit letzter Woche auf 2 Robotern. Die 6-dB-Regel war notwendig, ohne sie flackerte die Zone im Aufzugsvorraum alle paar Sekunden. Der Küchenalarm wurde schon einmal ausgelöst: Eine Reinigungskraft hat nach einem Kartenupdate am Roboter eine falsche Abzweigung genommen, und die Hauswirtschaft hat es innerhalb einer Minute bemerkt. Trotzdem würde ich die Anfrage gern weiterverfolgen, denn sie in der Firmware jedes Roboters umzusetzen ist aufwendig.
Running on 2 robots since last week. The 6 dB rule was necessary, without it the zone flickered every few seconds in the lift lobby. The kitchen alarm fired once already, a cleaner took a wrong turn after a map update on the robot, and housekeeping caught it in a minute. Still would like the request though, doing it in every robot’s firmware is work.
Von English mit KI übersetzt ·
UWB wurde für unsere Etagen auf etwa das 10-Fache der BLE-Tags angeboten, also dieses Jahr nicht. Die Zonengenauigkeit reicht mir, ich brauche sie nicht auf den Meter genau.
UWB was quoted at about 10x the BLE tags for our floors, so not this year. Zone level is enough for me, I don’t need it to the metre.
Von English mit KI übersetzt ·
Könntest du es irgendwie so einrichten, dass es per E-Mail ansagt? Also dass es den Posteingang liest?
Could you have it announce by e-mail somehow? Like read the inbox?
Von English mit KI übersetzt ·
Tyler, das ist perfekt. Ich habe ihm die Residency-Seite gezeigt (wir sind in den USA, es ist keine Residency-Anforderung festgelegt), und er hat sich deutlich beruhigt, als er den Export und die History-API-Route gesehen hat. Er möchte deine monatliche CSV-Idee als feste Aufgabe, also ist das wohl mein nächstes Projekt. Das Docker-Thema erwähne ich lieber nicht mehr, haha.
Tyler this is perfect. Showed him the Residency page (we’re US, no residency requirement set) and he calmed down a lot once he saw the export plus history API route. He wants your monthly CSV idea as a standing job, so I guess that’s my next project. Not mentioning the docker thing again, lol.
Von English mit KI übersetzt ·
Könntest du dem rechten Motor einfach etwas mehr PWM geben, bis er geradeaus läuft? Also etwa 70 zu 74?
Could you just give the right motor a bit more PWM until it tracks straight? Like 70 vs 74?
Von English mit KI übersetzt ·
Ein Docker-Image würde ihn sehr glücklich machen. Wo finde ich das? Ich habe unter Einstellungen nachgesehen und sehe nur Residency, Data Export und das Übliche.
A docker image would make him very happy. Where would I find that? I looked under Settings and only see Residency, Data Export and the usual stuff.
Von English mit KI übersetzt ·
Könnten Sie einen Stromsensor am Lüfterkabel anbringen und einen Alarm auslösen, wenn Strom fließt, obwohl er ausgeschaltet sein sollte?
Could you put a current sensor on the fan cable and alarm when current flows while it should be off?
Von English mit KI übersetzt ·
Gar nicht mein Fachgebiet, aber ich vermute Redundanz? Zwei von allem in der Sicherheit?
Not my field at all, but I’d guess redundancy? Two of everything in safety?

